Revit Architecture

Revit Architecture

Reply
Valued Contributor
bluicat
Posts: 87
Registered: ‎03-16-2009
Message 1 of 4 (332 Views)
Accepted Solution

Schedule Help Please Total Count for Graphic Parameter

332 Views, 3 Replies
04-06-2013 11:04 AM

Hello,

 

Thanks in advance for any help as I am stuck at the moment.


The attached schedule is all good except that I want to get a total for  the columns Duplex, Duplex GFI, Fourplex,

and Simplex. The schedule only shows the (1) column at the moment Duplex Total created as an additional paramter with calculated totals in the project.  I am trying to link that to the Duplex column etc...,

 

Please note that those columns Duplex, Duplex GFI, Fourplex, and Simplex are graphical yes/no paramters for my all in one outlet family created using the annotation symbols separatey loaded in a 3d wall hosted electrical family

then turned off and on accordingly.

 

 It's all working nicely expect  that the different heights are counting separately, when I want a total

of just Duplex's, Simplex's and so forth.

 

 

Thanks,

bluicat

Hi,

 

I figured it out.  I needed to create a shared parameter with an integer  - then I was able to connect it to outlet families and report the count.

 

Thanks for trying to help me anyway

bluicat

Active Member
cosstroe
Posts: 6
Registered: ‎04-05-2008
Message 2 of 4 (303 Views)

Re: Schedule Help Please Total Count for Graphic Parameter

04-06-2013 02:10 PM in reply to: bluicat

 go i Properties > FORMATING > Schedule Properties >Formatting and click then in left side :Field :smileyvery-happy:uplex> in the right side :  Field Formatting > Calculate Total ...CHECK IT

Valued Contributor
bluicat
Posts: 87
Registered: ‎03-16-2009
Message 3 of 4 (294 Views)

Re: Schedule Help Please Total Count for Graphic Parameter

04-06-2013 02:55 PM in reply to: cosstroe

Hi,

 

When I go to formatting and select Duplex the field for calculating totals is greyed out.  The only parameter that is not greyed out is the one that I added which is Duplex Total.  I think that I have to do some type of calculated value to link the Duplex to the added parameter Duplex Total?

 

bluicat

 

 

 

Valued Contributor
bluicat
Posts: 87
Registered: ‎03-16-2009
Message 4 of 4 (279 Views)

Re: Schedule Help Please Total Count for Graphic Parameter

04-06-2013 05:51 PM in reply to: cosstroe

Hi,

 

I figured it out.  I needed to create a shared parameter with an integer  - then I was able to connect it to outlet families and report the count.

 

Thanks for trying to help me anyway

bluicat

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.