As I am about to upgrade my student version of Revit 2012 to 2013 I would like some advice on the best configration/requirement to run Revit efficiently. Previously I have run Revit on an Imac using Parrallels but I experienced memory issues when rendering. I am switching across to my Mac tower computer OSX with the following: (Dual-Core Intel Xeon, Processor Speed: 2.66 GHz, Number Of Processors: 2, Total Number Of Cores: 4, L2 Cache (per processor): 4 MB, Memory: 5 GB, Bus Speed: 1.33 GHz, Boot ROM Version: MP11.005D.B00), I just dont want any problems with my other graphic design work on my computer - my income stream. Is the above configuration of my Mac tower ok for maximum Revit result or should I look at a new PC just for Revit? Please note I am not a tech head and will have to get a technician to transfer Parrallels and Revit to my tower if it is ok. I just dont want to spend dollars unnecassarily as I am a architectural student.
Did you ever get a solution to the below problem w Revit on a mac? I have the exact same problem you had, even down to the studying archetecture and punching out graphics for cash! quite funny ..
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!