How did you 'start' to make your revolving door? I would probably opened an
existing curtain wall door family, did a Saveas, and modified that to see if
I could get it to work.
Also, there is a revolving door family available at www.rugi.org but it's
wall based. But you might be able to reverse engineer that one to see how
to make your curtain panel version.
Ultimately, send your attempted door to Revit support, and they will help
you make it work.
SD
"Damir" wrote in message news:40b02e6d_2@newsprd01...
> Hi,
> I have a curtain wall and revolving doors inside it. Is it possible to
make
> so complex curtain wall panel? I was trying to make this new family the
> whole day, but curtain wall rejects it. Please, give me some suggestions.
>
> Damir Crnila
>
>