Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have modeled a family beam as seen in the photo attached. The top starts flat, then slopes up, down, and goes flat again along the length of the beam. I cannot get other standard beams to find attachments points to the beam. The modeled beam is an extrusion in the family. I've also looked into a sweep-blend with similar failure. What am I missing?!
