I need help with this as I can't find any reference to this anywhere else.
I've been upgrading to the 2014 for a little more than a week now and las week when I first tried to print a plan to our plotter I got the unpleasent surprise that I had a huge problem.
I short :
When I send a drawing from revit to the OCE TDS 500 it will eat a bit part of the drawing, I've tried to scaled, not to scale, in a paper format that is by far bigger then needed, I've tried more than one project, another computer and all with the same result.
Anyone know the problem or have a possible solution?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!