Revit Architecture

Revit Architecture

Reply
New Member
t_deferme
Posts: 1
Registered: ‎07-15-2011
Message 1 of 2 (459 Views)

Problem: visibility of a beam in plan view

459 Views, 1 Replies
07-15-2011 02:08 AM

If i draw a beam in plan view en define the height, the beam disepare. Is there a posibility that the beam is in place and you can see a dash dot line and two dashed lines in plan view?

 

thx

Active Contributor
mike
Posts: 28
Registered: ‎06-05-2008
Message 2 of 2 (430 Views)

Re: Problem: visibility of a beam in plan view

07-17-2011 02:18 PM in reply to: t_deferme

Most likely the beam level is above the view cut plane level. If you put in a plan region where the beam is located ( View tab / plan views / plan region ) and set this cut level to be through the beam, you can then see the beam.  You can then use the linework tool to get a dash dot line or however you would like it to display.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.