Revit Architecture

Revit Architecture

Reply
Active Member
craigj000
Posts: 8
Registered: ‎06-03-2009
Message 1 of 3 (398 Views)

Placing a void extrusion through a structural beam system (roof cladding)

398 Views, 2 Replies
05-25-2010 04:32 AM
I've made a corrugate roofing profile and then placed the profile in a beam system. All is going well until I get to the end of the roof where it has an angular cut rather than a 90° cut. I've tried placing a void extrusion through the overhanging roofing sheets but that hasn't appeared to have worked. Any suggestions would be greatly appreciated.
Mentor
bt1138
Posts: 253
Registered: ‎02-26-2009
Message 2 of 3 (398 Views)

Re: Placing a void extrusion through a structural beam system (roof cladding)

05-25-2010 03:08 PM in reply to: craigj000
Try this post:

http://discussion.autodesk.com/forums/thread.jspa?messageID=6379736壘

bt
Active Member
craigj000
Posts: 8
Registered: ‎06-03-2009
Message 3 of 3 (398 Views)

Re: Placing a void extrusion through a structural beam system (roof cladding)

05-25-2010 03:33 PM in reply to: craigj000
Awesome, cheers so much for that. What an interesting work around.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.