Revit Architecture

Reply
Active Contributor
twilks1
Posts: 41
Registered: ‎09-01-2009
Message 1 of 2 (287 Views)
Accepted Solution

Phase view control of shafts

287 Views, 1 Replies
12-05-2012 10:00 AM

I have a model with 15 floors and shaft objects in them. No matter what the Phase setting is for the shaft object the floor holes created by the shaft always show and cannot be eliminated with any Phase filter vew control. We need to adjust shaft locations and would like to maintain the cutting by shaft object through all floors. Any work arounds or methods??

This is a known issue that development is working on. It will most likely need a code fix to address. In the meantime I suggest using Marking Regions with Invisible Lines to hide the shafts.

 

Thanks for posting.

Product Support
alan.quinn
Posts: 616
Registered: ‎09-08-2010
Message 2 of 2 (260 Views)

Re: Phase view control of shafts

12-10-2012 08:37 AM in reply to: twilks1

This is a known issue that development is working on. It will most likely need a code fix to address. In the meantime I suggest using Marking Regions with Invisible Lines to hide the shafts.

 

Thanks for posting.



Alan Quinn
Support Specialist
Product Support
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.