Revit Architecture

Revit Architecture

Reply
Contributor
matthew.ram
Posts: 24
Registered: ‎12-06-2006
Message 1 of 3 (182 Views)

Multiple Wall Cuts causing issues with a Family

182 Views, 2 Replies
02-21-2011 02:32 PM

Good Afternoon,

 

I'm having a wierd issue poping up when I try to align a generic wall hosted family in a wall.

 

I've attached the project file with some text to show whats going on, as its kinda hard to explain whats happening.

 

Basically, I want this family to align at the joint of the two different walls, it needs to be flush with the face of the cutting wall, and I can't get it to work properly unless I unjoin the walls (keeping the cut) but then I get separate wall lines in plan view, that I dont' want.

 

Any help would be greatly appreciated.

Contributor Bal
Contributor
Bal
Posts: 23
Registered: ‎02-24-2010
Message 2 of 3 (152 Views)

Re: Multiple Wall Cuts causing issues with a Family

02-22-2011 10:18 AM in reply to: matthew.ram

Strange one.

 

If it meets the design requirements you can get it to 0.2mm (sorry for the metric, Brit here :smileytongue:)

 

I've attached that file.

 

What are you trying to do here anyway? Cut a reveal out of a wall?

 

Would be intresting in seeing the solution if you figure it out.

Contributor
matthew.ram
Posts: 24
Registered: ‎12-06-2006
Message 3 of 3 (150 Views)

Re: Multiple Wall Cuts causing issues with a Family

02-22-2011 10:34 AM in reply to: matthew.ram

I think i could get away with that small measurement.

 

And its a Soldier course brow, I actually have added model lines on that family to mimic the course pattern.

 

But i'm still curious what revit is thinking, and why its not possible to cut the wall when the walls are joined.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.