Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I created a sweep of a hollow metal door frame in the Family editor. The corner of the profile was on the path edge. After I made the sweep, I tried to move the frame so it would be centered on the wall, but couldn’t seem to do that. I started all over again and this time moved the profile before the sweep. The question is: can you move a sweep after you have made it into a sweep?
I tried the same, I could move the frame from top of the exterior to mid of the wall opening. But couldn't move horizontally. I would use the separate reference planes to move horizontally if needed.
