Revit Architecture

New Member
Posts: 2
Registered: ‎04-12-2013
Message 1 of 4 (484 Views)

Monolithic stair u-shaped

484 Views, 3 Replies
07-10-2013 03:40 AM

I have made a stair by sketch, an u-shaped one. I do have som problems with the 3d modell. it will not show up correctly. I add som printscreens and you can see. You know what i have to do to fix this?


Rogner stair.png

Rogner stair 2.png

*Expert Elite*
Posts: 1,803
Registered: ‎12-22-2012
Message 2 of 4 (426 Views)

Re: Monolithic stair u-shaped

07-12-2013 11:38 AM in reply to: glenn.roar.hoye

The first thing that comes to mind is that the view is cropped.





Don Ireland

If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.

Forum links:
AutoCAD 2013/2014/2015
AutoCAD 2010/2011/2012

AutoLISP, VB and other AutoCAD customization

Civil 3D General
Civil 3d Customization

Other Helpful links:
My File is too large to post!
Valued Mentor
Posts: 345
Registered: ‎08-05-2012
Message 3 of 4 (415 Views)

Re: Monolithic stair u-shaped

07-12-2013 01:16 PM in reply to: glenn.roar.hoye

Use one of the following methods may be your problem.:

1 - Reduce the thickness of the stairs.

2 - in the landing areas, with separate Split.

3 - In the Type Properties and Type Properties dialog box, click Run type in new window Stepped put option on the Underside Surface.

4-Monolithic type steps of change.

New Member
Posts: 1
Registered: ‎01-08-2014
Message 4 of 4 (243 Views)

Re: Monolithic stair u-shaped

01-08-2014 08:11 AM in reply to: gh_ar
Everyone should thank you so much!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.