Last night I was editing an In-Place family and for some reason, Revit did not exit the In-Place Editor properly. The Modify tab was kicked all the way to the left on the ribbon to precede the Home tab. Is there a way to reset the ribbon to its default state because, the contextual tabs react to the new location of the Modify tab? I have attached an image.
I am using a M6400 Dell Precison Laptop with Win 7 64 and SP1 has been installed to Revit Architecture
Solved! Go to Solution.
Solved! by Bill.Knittle. See the answer in context.
Thanks for the tips. Ctrl+Drag worked great!!!
There are 2 approaches to resolve this:
1. You can rearrange tabs while holding the CTRL key:
2. You can reset the UI back to default [which will reset any QAT or ribbon customization]:
Hope this helps!
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!