Revit Architecture

Reply
Mentor
Lineabove
Posts: 231
Registered: ‎06-30-2008
Message 1 of 4 (1,298 Views)

Miter Wall Join (as default)

1298 Views, 3 Replies
02-26-2011 03:59 PM

It seems to me that it would make more sense to have the Miter Wall join as default.

If that is not applicable then default to Square Off.

 

Or at least have the option to set the Wall Join to Miter (smiilar to selecting your Snaps)

 

Or am I missing something ?

Alumni
kathryn.langan
Posts: 467
Registered: ‎12-16-2008
Message 2 of 4 (1,266 Views)

Re: Miter Wall Join (as default)

02-28-2011 01:10 PM in reply to: Lineabove

Wall Joins will always default to the Butt type, but you can configure the join after placement: Changing the Configuration of a Wall Join.

 

If you would like to request the ability to change the default behavior, I would suggest doing so at the Feedback Site.

 

I hope this helps!



Katie Langan
Technical Support Specialist
Customer Service & Support
Autodesk, Inc.

New Member
MiklosF
Posts: 1
Registered: ‎01-30-2014
Message 3 of 4 (597 Views)

Re: Miter Wall Join (as default)

01-30-2014 03:53 AM in reply to: kathryn.langan

Hi,

 

I would like to know about if there was a development in REvit about the default settings.

  • Can we change the default "Butt" setting? 
  • Is there any shorter way to change the existing join instead of selecting all corners one by one on floor plan view?

 

I appreciate any feedback. Thank you.

Active Contributor
duncan.lithgow
Posts: 44
Registered: ‎04-13-2012
Message 4 of 4 (413 Views)

Re: Miter Wall Join (as default)

05-20-2014 05:08 AM in reply to: MiklosF

That Feedback site is no use. I can't see if anyone else has already registeret this as an issue!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!