Revit Architecture

Reply
*Doug
Message 1 of 3 (293 Views)

Kohler Tubs

293 Views, 2 Replies
01-20-2004 05:09 AM
I have imported a Kohler DWG file into Revit. PROBLEM: All of the whirlpool tube jets are 90 degrees to the surface of the tub. This is not the case when I open the file in ADT 3.0. Any Solutions? Doug
*Aaron Rumple
Message 2 of 3 (293 Views)

Re: Kohler Tubs

01-20-2004 08:44 AM in reply to: *Doug
Are the jets a block with non-uniform scaling or have they been mirrored in AutoCAD? AutoCAD can do some strange things with the UCS that affects import into other projrams. "Doug" wrote in message news:400d28a5$1_2@newsprd01... > I have imported a Kohler DWG file into Revit. > PROBLEM: > All of the whirlpool tube jets are 90 degrees to the surface of the tub. > This is not the case when I open the file in ADT 3.0. > > Any Solutions? > > Doug > >
Distinguished Contributor
Steve_Stafford
Posts: 572
Registered: ‎12-20-2001
Message 3 of 3 (293 Views)

Re: Kohler Tubs

01-20-2004 11:36 AM in reply to: *Doug
Just a thought, but there are quite a few Kohler based families on www.rugi.org Have you checked them out? If not, what you want might already be there?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.