Revit Architecture

Revit Architecture

Reply
Active Member
Scott Foss
Posts: 8
Registered: ‎07-12-2004
Message 1 of 2 (96 Views)

Joining Solids - created in place

96 Views, 1 Replies
09-17-2004 08:35 AM
I have created three solids representing a fireplace surround.

How can I join these three items? Trim? Join geometry?

Not sure if this is possible without creating a sweep. However creating a sweep vertically doesn't seem possible.

Help.
*JTB
Message 2 of 2 (96 Views)

Re: Joining Solids - created in place

09-17-2004 09:15 AM in reply to: Scott Foss
You will see my post about sweep problems... I guess the best way to do such things is in-place families. Then you can use join geometry. Before you experiment with those, wait for more answers, because I am new to Revit too! :-)) Ï "Scott Foss" Ýãñáøå óôï ìÞíõìá news:4814457.1095435365086.JavaMail.jive@jiveforum1.autodesk.com... > I have created three solids representing a fireplace surround. > > How can I join these three items? Trim? Join geometry? > > Not sure if this is possible without creating a sweep. However creating a sweep vertically doesn't seem possible. > > Help.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.