Revit Architecture

Revit Architecture

Reply
New Member
w.q.deboer
Posts: 1
Registered: ‎09-27-2012
Message 1 of 2 (291 Views)

How to make rounded edge wall and roof

291 Views, 1 Replies
09-27-2012 08:05 PM

I am trying to get my drawings into revit but I am stuck on getting the basic form of the building in Revit.

 

Since I am using slanted walls I need to work with a Mass but I can't get the mass look like my idea. The picture I attached is a simpel screen caputre of Rhino withthe outline of the building.

 

I hope you guys can help!

Employee
davissc
Posts: 293
Registered: ‎08-08-2007
Message 2 of 2 (277 Views)

Re: How to make rounded edge wall and roof

09-27-2012 11:34 PM in reply to: w.q.deboer

draw the same profile you used in Rhino, on the surface vertical workplane in the Mass Editor in Revit, and then use the Create Form buttom to turn the profile into an extrusion.



Scott D Davis
AEC Technical Specialist
North American Sales
Autodesk, Inc.

Want Revit Content? Go to http://seek.autodesk.com !

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.