Revit Architecture

Reply
Mentor
163 Posts
2 Kudos
Registered: ‎09-19-2011
Post 1 of 3
Accepted Solution

How to cut a mullion?

177 Views, 2 Replies
01-27-2014 06:55 AM

Hi,

 

I'm trying to create a sloped glazing roof but I'm having problems with the end mullion. I wanted Revit to cut the last mullion so that the boundary that I defined is completely covered. As it seems, Revit either adds a complete last mullion, surpassing the boundary, or removes the last mullion, creating a hole on the roof. I tried using a vertical shaft to cut the last mullion that surpasses the prescribed boundary but had no success..

 

How would you accomplish this?

 

Thanks

 

---------------------------------------

Using Building Design Suite Ultimate 2015

I can try that...I thought there would be a faster and cleaner way though...

 

I just realized that the sloped glazing roofs adds an empty system panel at each grid...i can use that to cut the mullion....

 

thanks

Sloped Glazing.png

Valued Contributor
88 Posts
12 Kudos
Registered: ‎09-18-2013
Post 2 of 3

Re: How to cut a mullion?

01-27-2014 07:19 AM in reply to: ruipfbarreiros

Hi, have you tried a void to cut the mullion instead of a shaft? Shafts only cuts floors and roofs, i think. But i've created a sloped roof here, with a chamfer in one of the corners so the end mullion gets shorter, and worked fine. Could you post a image of what you're trying to do?

 

Gustavo

Mentor
163 Posts
2 Kudos
Registered: ‎09-19-2011
Post 3 of 3

Re: How to cut a mullion?

01-27-2014 07:43 AM in reply to: gustavomello

I can try that...I thought there would be a faster and cleaner way though...

 

I just realized that the sloped glazing roofs adds an empty system panel at each grid...i can use that to cut the mullion....

 

thanks

Sloped Glazing.png

---------------------------------------

Using Building Design Suite Ultimate 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post