Revit Architecture

Reply
Active Contributor
kukuzry
Posts: 39
Registered: ‎05-05-2010
Message 1 of 4 (460 Views)

How to annotate Ellipse?

460 Views, 3 Replies
06-17-2013 12:10 PM

I am creating a family which uses an elliptical extrusion. However, I cannot bind the dimension of the ellipse to the parameters. How can I annotate the dimension of the ellipse? Thanks.!

*Expert Elite*
Alfredo_Medina
Posts: 2,830
Registered: ‎06-11-2009
Message 2 of 4 (453 Views)

Re: How to annotate Ellipse?

06-17-2013 12:30 PM in reply to: kukuzry

If is not difficult to place dimensions to control the size of the ellipse. For example, if you want to control total width or total height, simply dimension from one blue square dot to the one on the other side. If you need to measure from the center to a quadrant, turn on the center mark, and measure from there to a quadrant. Even the focus points are available if you turn them on, from the Properties window.

-----------------------------------------------------------------------------------------------------------------
Planta1 Revit Online Consulting | info@planta1.com | my Twitter | The Planta1 Blog
Active Contributor
kukuzry
Posts: 39
Registered: ‎05-05-2010
Message 3 of 4 (443 Views)

Re: How to annotate Ellipse?

06-17-2013 12:49 PM in reply to: Alfredo_Medina

I attach the file.  There is a ellipse and  I want to bind the "Width" and "Length" parameters to ellipse width and height. 

 

However, I tried but cannot bind them, could you help me check it why I can not do that ? Thanks,

Active Contributor
kukuzry
Posts: 39
Registered: ‎05-05-2010
Message 4 of 4 (436 Views)

Re: How to annotate Ellipse?

06-17-2013 01:00 PM in reply to: kukuzry

I figure it out. I should edit it in boundary not in extrusion shape....

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.