Revit Architecture

Reply
Member
tace86
Posts: 3
Registered: ‎08-27-2012
Message 1 of 1 (108 Views)

Help/Suggestions for making a family

108 Views, 0 Replies
08-27-2012 05:45 PM

Hi all,

 

I am fairly new to REVIT (using Revit Architecture 2013 - Windows7 64Bit) and was wondering if anyone has any suggestions to enable me to make a block with the following attributes/parameters.

 

Basically, we have a row of inground tanks, which need to be at the same invert level, however due to the slab falls on the site, the manhole openings are at different heights (and these change from site to site).  We were hoping to be able to make a block in which the manhole would automatically snap to the host height so that the "funnel's" down to the tanks are different heights.

 

We use this configuration for almost all of our sites and at the moment it is very time consuming to individually model each situation, and even more so when the site levels change constantly.

 

Does anyone have any idea if this can be achieved and if so, how is the best way to go around it?

 

Thanks in advance,

 

Stacey B

 

TANK REQUEST REVIT.png

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.