Revit Architecture

Reply
Member
Kaducki
Posts: 3
Registered: ‎03-23-2013
Message 1 of 2 (293 Views)

Elliptical sloped roof in Revit

293 Views, 1 Replies
01-23-2014 03:57 PM
Hi, I'm using Revit 2014 Student version and have problem with creating elliptical roof. If I wanted it to be flat, it wouldn't be a problem. But I need it to be lower near the center of ellipse and higher at outer edge of this elliptical "ring". As you probably know, this "ring" doesn't have constant witdh, as it's elliptical. So I can't just define 30 degrees slope, because height at outer edge would be diffrent in every part. See attachments to understand me.
*Expert Elite*
Paul_F_Aubin
Posts: 99
Registered: ‎11-13-2006
Message 2 of 2 (252 Views)

Re: Elliptical sloped roof in Revit

01-24-2014 05:04 AM in reply to: Kaducki
Does the Student version have the "Shape Editing" tools? Click your flat roof, then on the ribbon look to see if the shape editing panel appears. If so, try putting a single point at the center of the ellipse. Then on the same panel, click the Modify Sub Elements tool and give this point a height; probably a negative number if I understand what you described. I think that should do the trick.
paul

Paul F. Aubin

Paul F. Aubin Consulting Services
Check out my newest book: Renaissance Revit!
http://www.paulaubin.com
Revit Essentials Training at lynda.com/paulaubin
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.