Revit Architecture

Revit Architecture

Reply
Distinguished Contributor
diesellam
Posts: 158
Registered: ‎01-26-2009
Message 1 of 2 (544 Views)

Electrical switches not show up in RCP

544 Views, 1 Replies
09-19-2012 04:22 PM

I setup my ceiling plan so that I see all of the light fixtures on my sloped ceilings.

But I can't see my electrical switches, why?

 

I check my VV and the electrical componets is checked for visibility.

What do I have to do to make them show up?

 

*Expert Elite*
CADastrophe
Posts: 3,421
Registered: ‎08-28-2009
Message 2 of 2 (534 Views)

Re: Electrical switches not show up in RCP

09-20-2012 06:01 AM in reply to: diesellam

Have you checked the View Range? The default RCP Cut Plane is at 7' - 6", which is well above the traditional light switch mounting height. Lower the Cut Plane to somewhere below the switch.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.