Revit Architecture

Reply
New Member
stevesearles
Posts: 2
Registered: ‎08-01-2012
Message 1 of 4 (1,567 Views)

Driveway in Revit

1567 Views, 3 Replies
08-01-2012 06:47 PM

Is there now a standard procedure to create a sloping driveway in Revit ??   

Valued Contributor
vector3
Posts: 99
Registered: ‎06-29-2012
Message 2 of 4 (1,555 Views)

Re: Driveway in Revit

08-01-2012 09:49 PM in reply to: stevesearles

Welcome to the forum Steve.

 

Super easy to make sloped floor. Make your concrete
slab driveway, usually on the ground, and before
you finish your sketch lines, hit "Slope Arrow" on
the Modify ribbon.

 

Then from the center of one end of the driveway
draw the arrow to the other end.

 

Then just look over on the properties pallet and
see the settings for tail height and head height
and offset etc. Then click the green check on the
ribbon and you got it.

Employee
loboarch
Posts: 1,012
Registered: ‎09-05-2003
Message 3 of 4 (1,535 Views)

Re: Driveway in Revit

08-02-2012 05:55 AM in reply to: stevesearles

A pad or a floor element can be used to create a drive if it is one element and pretty much one slope.  If you need the drive to follow contours or curve you can use a sub-region on the toposurface and then assign a different material to the subregion.



Jeff Hanson
Sr. Subject Matter Expert
Autodesk, Revit User Experience
Valued Contributor
vector3
Posts: 99
Registered: ‎06-29-2012
Message 4 of 4 (1,521 Views)

Re: Driveway in Revit

08-02-2012 09:43 AM in reply to: loboarch

loboarch wrote:

If you need the drive to follow contours or curve you can use a sub-region on the toposurface and then assign a different material to the subregion.


One of the most important short videos available, must see for everyone.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!