Revit Architecture

Reply
*Expert Elite*
3,478 Posts
997 Kudos
Registered: ‎08-28-2009
Post 11 of 14

Re: Doors in angled walls

11-09-2012 12:58 PM in reply to: GRandall

GRandall wrote:

"Yes I can do that but under no circumstances do temporary dimensions function on the non ortho walls."


Seems true - no temporary dimension on a Wall that joins at an angle with another Wall. Revit doesn't always do too well when angles are involved.

 

What I did below is drag the endpoint of the Walls to make the joint with the angled Wall a right angle, and then the temporary dims become available. However, if you make the dimensions permanent and correct the Walls, the dimensions are lost. There's not much I can contribute here, so I hope this is of some help.

 

AngledWallDims.JPG

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Contributor
22 Posts
0 Kudos
Registered: ‎11-07-2012
Post 12 of 14

Re: Doors in angled walls

11-09-2012 02:15 PM in reply to: CADastrophe

I have found that using temporary model lines can be a great aid to locating or moving objects that are otherwise difficult to snap to or adjust using normal methods.

SG

*Expert Elite*
2,887 Posts
363 Kudos
Registered: ‎06-11-2009
Post 13 of 14

Re: Doors in angled walls

11-09-2012 03:22 PM in reply to: CADastrophe

Probably a pinned reference plane, perpendicular to the angled wall, could be used to control the distance of the door to a corner, with a dimension.

-----------------------------------------------------------------------------------------------------------------
Planta1 Revit Online Consulting | info@planta1.com | my Twitter | The Planta1 Blog
Valued Contributor
82 Posts
0 Kudos
Registered: ‎05-28-2008
Post 14 of 14

Re: Doors in angled walls

11-12-2012 07:52 AM in reply to: GRandall

Thanks for the suggestions, still a Revet newbie, I'll try them until I find the easiest. Sure seems like there should be some sort of plascement constraint for doors and windows similar to ACA;s for center, offset, etc., since Revit is purported to be the "best".

 

Wish List anyone

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post