Revit Architecture

Revit Architecture

Reply
Valued Contributor
dtdesign
Posts: 61
Registered: ‎04-03-2012
Message 1 of 3 (950 Views)
Accepted Solution

Door Swing Graphics at 'New Construction' Phase

950 Views, 2 Replies
11-22-2012 04:57 AM

Does anyone know a way to fix this?  Whenever I do a renovation project all the doors show in elevation with a heavy swing line when the view is set for 'Show New' or 'Show Complete'.  Normally, doors show the swing line as a thin dashed or hidden line.  For the life of me, I cannot adjust this graphic either through the graphics override or through the phase settings.

 

Anyone know how to do this?

 

Thanks in advance!

 

Dave

Got the answer -

 

I reset the Overrides in the Graphics Overrides for projection lines.  Almost too simple - but buried deep...

Valued Contributor
dtdesign
Posts: 61
Registered: ‎04-03-2012
Message 2 of 3 (942 Views)

Re: Door Swing Graphics at 'New Construction' Phase

11-22-2012 05:45 AM in reply to: dtdesign

Also - I find that I cannot adjust components on a stair in the 'Show Complete' phase either - such as the risers of the plan showing as 'Overhead', etc.  I tried messing around with filters, but it isn't adjusting components, just the entire family in view...this is frustrating..

Valued Contributor
dtdesign
Posts: 61
Registered: ‎04-03-2012
Message 3 of 3 (933 Views)

Re: Door Swing Graphics at 'New Construction' Phase

11-23-2012 03:11 AM in reply to: dtdesign

Got the answer -

 

I reset the Overrides in the Graphics Overrides for projection lines.  Almost too simple - but buried deep...

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.