I believe that it is impossible to influence the range of dimension ticks or arrows that are included with the OTB Revit, Arch, Str, MEP etc, but does anyone know if it is possible using the Revit Software Development Kit? I wish to know because I would like to have a dimension 'tick' that shows as 'X' not the usual '/' and do not want to launch into learning how to use the SDK if it is not able to help.
I would recommend you contacting our ADN development team directly:
Hope that helps!
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!