Revit Architecture

Revit Architecture

Valued Contributor
Posts: 72
Registered: ‎10-25-2013
Message 1 of 2 (406 Views)
Accepted Solution

Creating two different types of ground floor slabs on the same level?

406 Views, 1 Replies
12-12-2013 01:46 AM


I'm trying to separate my ground floor slab into two different slabs each with a different stratigraphy of layers.  How can I do this?  I've edited the footprint so that it looks like there are two distinct floor boundaries but when I go to select the floor in order to edit the type, the entire floor, or both "pieces" get selected and I can't seem to just edit one piece.... any suggestions?

*Expert Elite*
Posts: 2,486
Registered: ‎12-09-2003
Message 2 of 2 (365 Views)

Re: Creating two different types of ground floor slabs on the same level?

12-14-2013 07:54 PM in reply to: amontri
You need to create two separate slabs. If the outline of your slab is intricate and you would prefer not to retrace one part, you should be able to edit the slab boundary and cut the boundary lines from the area for the "other" slab, then draw in the closing edge lines and accept the edits. Then start a new slab and paste the cut lines to start the boundary sketch of the "other" slab.
David Koch
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.