Revit Architecture

Reply
*Damian Bree - BDP
Message 1 of 2 (984 Views)

Coping to top of Parapet Wall

984 Views, 1 Replies
05-09-2004 03:49 AM
I'm looking for a way to place a concrete coping to the top of a (level) parapet wall. I cannot find any such family in the library, but being new to Revit I may be looking in the wrong area, or using UK terminology. Any guidance please? On a similar vein, at the other end of the wall, is there a Foundation (sometimes called footing) family, so that the structure is represented correctly in sections? Thanks Damian
*Aaron Rumple
Message 2 of 2 (984 Views)

Re: Coping to top of Parapet Wall

05-10-2004 06:13 AM in reply to: *Damian Bree - BDP
1. You can either design the coping into the wall family using a wall sweep. Or you could create a hosted sweep on just specific walls. The tutorials have a good exercise for learning how to do this. 2. For foundations you can use: A short fat wall. A wall sweep. A hosted sweep. A floor. Much depends on the construction details of the project. "Damian Bree - BDP" wrote in message news:409e0cbd$1_2@newsprd01... > I'm looking for a way to place a concrete coping to the top of a (level) > parapet wall. > > I cannot find any such family in the library, but being new to Revit I may > be looking in the wrong area, or using UK terminology. Any guidance please? > > On a similar vein, at the other end of the wall, is there a Foundation > (sometimes called footing) family, so that the structure is represented > correctly in sections? > > Thanks > > Damian > >
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.