Revit Architecture

Revit Architecture

Posts: 5
Registered: ‎08-22-2012
Message 1 of 1 (285 Views)

Composite Walls vs Built-up walls

285 Views, 0 Replies
08-22-2012 02:02 AM

I am after advice on how best to build-up complext external walls that will comprise multiple trades and allow the specialist cladding elements to be replaced by the subcontractor modelled elements: eg I have:

  1. Internal plasterboard lining
  2. metal structural framing with insulation between - specialist design and install
  3. sheathing board - specialist design and install
  4. cladding system - specialist design and install

I can do this to a degree with a Composite walls, but each element will stop and start in different places and each will be installed by a different trade.


is it better to model separately to get better output from QTO and to allow for the replacement of specialist models?


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.