Revit Architecture

New Member
Posts: 2
Registered: ‎05-31-2011
Message 1 of 2 (201 Views)

Cape/Colonial House Details Need Help

201 Views, 1 Replies
05-31-2011 08:56 AM

Im relatively new to revit and I cant figure out how to add trim to the faces of buildings.  I know how to sweep a crown around the walls but vertical trim is what im struggling with.  Also how do you make a profile to sweep?  My last question pertains to wall sections.  How do you show a typical stacked wall section with blocks, joists,floors, rafters and roof?  WOuld you do all of this using the edit structure tool in type properties or would you do this in a callout?  Any advice, tips, or pointers would be great and very useful. Thanks.

*Expert Elite*
Posts: 2,521
Registered: ‎12-09-2003
Message 2 of 2 (194 Views)

Re: Cape/Colonial House Details Need Help

06-01-2011 03:42 PM in reply to: benjamin.strong
Posting your question in the Revit Architecture Discussion Group will likely get you a better response than here in the AutoCAD Architecture Content Discussion Group.
David Koch
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.