Revit Architecture

Revit Architecture

Reply
Contributor
marcus
Posts: 17
Registered: ‎05-30-2011
Message 1 of 3 (239 Views)
Accepted Solution

Can you edit floor sub-components in section?

239 Views, 2 Replies
11-14-2012 08:53 AM

I have a floor joist/subfloor/finish floor system where the joists are hung from the sill inside the foundation wall, this means that the joists stop at the wall but the subfloor will continue over the sill plate and the finish floor will stop at the inside edge of the bottom wall plate.  As near as I can figure, in order to get this to show correctly in section I really need to create the complete floor assembly by stacking 3 separate floor sub-assemblies (framing, sub-floor, finish floor) is this correct? (this is the method I'm currently using) Is there a way to manipulate the sub-components in section that I haven't found? 

 

Thanks

Hello Marcus - what you currently have is correct.

If you need to manipulate the materials separately you would need to place them separately and layer them on top of each other.

 

LD

*Expert Elite*
LisaDrago
Posts: 1,392
Registered: ‎05-08-2009
Message 2 of 3 (214 Views)

Re: Can you edit floor sub-components in section?

11-19-2012 06:19 AM in reply to: marcus

Hello Marcus - what you currently have is correct.

If you need to manipulate the materials separately you would need to place them separately and layer them on top of each other.

 

LD


If this helped solve your issue - remember to 'accept as solution' to help other find answers!
You can't think AutoCAD and run Revit.
Email: LisaDragoEE@gmail.com
Contributor
marcus
Posts: 17
Registered: ‎05-30-2011
Message 3 of 3 (191 Views)

Re: Can you edit floor sub-components in section?

11-20-2012 06:06 AM in reply to: LisaDrago

Lisa,

 

Thanks for your feedback, that's kind of what I figured. 

 

I haven't had to try it, but I'm going to assume that roofs behave the same way. 

 

Maybe this could be a wish list item...if there was a Revit Architecture wish list.  I guess that getting an RA wish list would be a wish list item as well?? lol

 

Thanks,

Marcus

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.