Revit Architecture

Revit Architecture

Reply
New Member
jukebar
Posts: 1
Registered: ‎08-17-2012
Message 1 of 1 (126 Views)

Basic Question: Roof Assemblies

126 Views, 0 Replies
08-17-2012 05:48 AM

I am a novice with REVIT. I have created a roof assembly using a pre-engineered truss as the structure and cut a section through the building, the truss profile does not appear. If I load a truss family into the project and then space the trusses evenly througout in attempt to represent the construction accurately, am I creating redundancy with essentially two sets of trusses? The same can be said when using dimensional lumber, the individual members do not show in section when cut. I realize 2-d detail can be overlayed in section cuts, but should I expect to see individual members in section cuts?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.