Revit Architecture Forum
Welcome to Autodesk’s Revit Architecture Forums. Share your knowledge, ask questions, and explore popular Revit Architecture topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

auto fraction stack

3 REPLIES 3
Reply
Message 1 of 4
dcooper
2324 Views, 3 Replies

auto fraction stack

How do you enable stacked fractions for dimensions in Revit 2013?

3 REPLIES 3
Message 2 of 4
AJA14
in reply to: dcooper

Hi. In the type properties of the dimensions, change the units to feet and fractional inches and choose the appropriate rounding. Remember you can also override dimensions if you don't need to create a new type.

 

If this solves your problem, Please accept as solution.

Ali Al-Hammoud
Structural Design Engineer
MZ & Partners Engineering Consultancy
Message 3 of 4
dcooper
in reply to: AJA14

I already had that set. That setting does not cause the fraction to stack. Both numerator and denominator are side by side on the same line separated by a "/".

Message 4 of 4
VWD-MLM
in reply to: dcooper

Stacked Fractions are not possible in any of the Revit flavors.............It's been asked for as long as I can remember (2007)

 

Mike

Michael L. Maloney
Virtual World Designs
VDC & BIM Model Design, Clash & Coordination
mike@VirtualWorldDesigns.com
BDSU 2015, 2016
Charlotte, NC ; Fort Mill, SC

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report