Revit Architecture

Active Contributor
46 Posts
37 Kudos
Registered: ‎02-20-2010
Post 1 of 4

auto fraction stack

1211 Views, 3 Replies
01-27-2013 03:45 PM

How do you enable stacked fractions for dimensions in Revit 2013?

Valued Mentor
494 Posts
58 Kudos
Registered: ‎11-01-2011
Post 2 of 4

Re: auto fraction stack

01-27-2013 09:44 PM in reply to: dcooper

Hi. In the type properties of the dimensions, change the units to feet and fractional inches and choose the appropriate rounding. Remember you can also override dimensions if you don't need to create a new type.


If this solves your problem, Please accept as solution.

Ali Al-Hammoud
Structural Design Engineer
MZ & Partners Engineering Consultancy
Active Contributor
46 Posts
37 Kudos
Registered: ‎02-20-2010
Post 3 of 4

Re: auto fraction stack

01-28-2013 02:34 AM in reply to: AJA14

I already had that set. That setting does not cause the fraction to stack. Both numerator and denominator are side by side on the same line separated by a "/".

Valued Mentor
265 Posts
23 Kudos
Registered: ‎03-04-2004
Post 4 of 4

Re: auto fraction stack

01-28-2013 04:21 AM in reply to: dcooper

Stacked Fractions are not possible in any of the Revit flavors.............It's been asked for as long as I can remember (2007)



Michael L. Maloney
Virtual World Designs
VDC & BIM Model Design, Clash & Coordination
Building Design Suite Ultimate 2013, 2014, 2015
Charlotte, NC ; Fort Mill, SC
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!