Revit Architecture

Active Member
Posts: 8
Registered: ‎05-22-2006
Message 1 of 2 (176 Views)

area boundaries in groups

176 Views, 1 Replies
10-15-2012 10:36 PM

having some very strange issues with area boundaries used in groups.


I have tested it in RAC 2011, 2012 and 2013 and they all seem to be doing similar things.


grouping them and pasting them is fine - even between levels and even schemes. when i edit them items are excluded on sketch close and even disapear from one scheme to only apear in the scheme that i edited them in. the area still remains in both but only boundaries in one scheme.


any ideas?

Product Support
Posts: 358
Registered: ‎05-14-2010
Message 2 of 2 (129 Views)

Re: area boundaries in groups

10-25-2012 11:50 AM in reply to: cooperw

I tried going through some similar steps in a new project, and I am not seeing what you are describing.


If you are able to reproduce this behavior in a new (small) project file, can you post it to the thread with instructions on the steps you are going through?


If you are not able to reproduce this behavior in a new project file, the following blog posting has information on tools that may help troubleshoot the project:

Tools for Troubleshooting Unexpected Behavior in Revit

Lance Coffey
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.