Revit Architecture

Revit Architecture

Reply
New Member
jkunkel0004
Posts: 2
Registered: ‎04-16-2013
Message 1 of 4 (754 Views)

Arched Hole in wall & Wall height

754 Views, 3 Replies
04-16-2013 09:41 AM

I am trying to make a floorplan of my house in Revit 2013, but I am having an issue when it comes to one wall in my house. I have an opening in the Master Bedroom that leads to the bathroom. This wall has a weird arched-like opening in it and I have no clue how to make this in Revit. I have attached a sketch I did in paint so you guys can see what I am talking about.

 

Also, my exterior walls are 7' tall but the interior walls start at 7' and go up to 8' once in the middle of the house and reduce back to 7". How does one set that up in Revit?

 

EDIT: May have made the image too small to see, but the top is not arched, it is actually half of a decagon.

*Expert Elite*
constantin.stroescu
Posts: 1,118
Registered: ‎10-29-2008
Message 2 of 4 (661 Views)

Re: Arched Hole in wall & Wall height

04-16-2013 09:53 AM in reply to: jkunkel0004

you can do it by selecting wall and the : Mode>Edit Profil

Constantin Stroescu
BIM Manager AGD
*Expert Elite*
constantin.stroescu
Posts: 1,118
Registered: ‎10-29-2008
Message 3 of 4 (651 Views)

Re: Arched Hole in wall & Wall height

04-16-2013 10:16 AM in reply to: jkunkel0004

Edit Profil is a quick method to solve the problem localy.

If you want to repeat the hole many times in your project, it will be better to make a Family:

New Family> (Metric) Door...erase the frame mullion extrusions...in an Elevation View put the mouse over the border of the hole and TAB (from keyboard) till the Opening Cut is heighlighting in blue..then click..now the hole is selected ..Opening>Edit Sketch...erase the upper line of the hole border and draw an inscribed  poligon with 10 sides centered on  equal distanecs from the left and right border....make it parametric and load it into your project.

Constantin Stroescu
BIM Manager AGD
*Expert Elite*
constantin.stroescu
Posts: 1,118
Registered: ‎10-29-2008
Message 4 of 4 (642 Views)

Re: Arched Hole in wall & Wall height

04-16-2013 10:50 AM in reply to: jkunkel0004

as for the wall 7-8-7 you can use

  1. Wall >Edit Profil  
  2. or you can attach it to an Extruded Roof  or two joined sloped floors 
Constantin Stroescu
BIM Manager AGD
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.