Revit Architecture

Revit Architecture

Reply
New Member
HLOpstraat
Posts: 2
Registered: ‎01-20-2014
Message 1 of 3 (413 Views)
Accepted Solution

aligning two curtain walls/panels in a Blob-like form

413 Views, 2 Replies
01-20-2014 01:38 AM

Good day everyone,

 

I'm trying to figure out a small problem I have with creating a Blob-like form. I've created a mass by creating a form out of six (two per level) reference lines. The Form comes out nice, but whenever I divide the form, the two created surfaces don't align with eachother. Therefore, when I create curtain walls or patterns on this form, they don't match up either.

 

I have attached two images and a Conceptual massing file with the mass inside. I Hope someone can provide me with a solution for this problem.

 

Thanks in advance, Leo

*Expert Elite*
constantin.stroescu
Posts: 989
Registered: ‎10-29-2008
Message 2 of 3 (386 Views)

Re: aligning two curtain walls/panels in a Blob-like form

01-20-2014 03:27 AM in reply to: HLOpstraat

the alignement control is made from Belt Measurement settings:

Image 1.png

 

 

Image 2.png

 

Belt can be graphicaly activated by clicking on the small central rectangle as shown below:

Image 5.png

 

 

Image 6.png

Constantin Stroescu
BIM Manager AGD
New Member
HLOpstraat
Posts: 2
Registered: ‎01-20-2014
Message 3 of 3 (374 Views)

Re: aligning two curtain walls/panels in a Blob-like form

01-20-2014 04:30 AM in reply to: constantin.stroescu

Thank you, this will greatly help me in my project!

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.