aligning two curtain walls/panels in a Blob-like form

[HLOpstraat]

Good day everyone,

I'm trying to figure out a small problem I have with creating a Blob-like form. I've created a mass by creating a form out of six (two per level) reference lines. The Form comes out nice, but whenever I divide the form, the two created surfaces don't align with eachother. Therefore, when I create curtain walls or patterns on this form, they don't match up either.

I have attached two images and a Conceptual massing file with the mass inside. I Hope someone can provide me with a solution for this problem.

Thanks in advance, Leo

[constantin.stroescu · Accepted solution]

the alignement control is made from Belt Measurement settings:

Belt can be graphicaly activated by clicking on the small central rectangle as shown below:

[HLOpstraat]

Thank you, this will greatly help me in my project!