Revit Architecture

Revit Architecture

Reply
Member
vicz615
Posts: 5
Registered: ‎03-22-2013
Message 1 of 2 (219 Views)

Adding a truss into Revit and placing it at the correct height

219 Views, 1 Replies
11-11-2013 10:56 AM

Sometimes I'm unable to place a truss in my building. When I am able to get it in, it's never at the right height (either too high or too low). I've tried moving it in an elavation and section, but it will only move left and right, not up and down. Is there a way to fix this problem? My teacher said something about changing the veiw range, which I did...I'm just not sure I did it correctly.

*Expert Elite*
constantin.stroescu
Posts: 1,118
Registered: ‎10-29-2008
Message 2 of 2 (199 Views)

Re: Adding a truss into Revit and placing it at the correct height

11-11-2013 12:31 PM in reply to: vicz615

The beam is placed on Work Plane, so , if you want to move it verticaly you have to:

  1. Change the Work Plane (1,2)
  2. In Properties>Constraints > adjust Start Level Offset and End Level Offset to place at a certain distance from the Level (3)

Image 328.png

Constantin Stroescu
BIM Manager AGD
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.