Revit Architecture

Revit Architecture

Reply
Mentor
MKEllis
Posts: 228
Registered: ‎03-02-2013
Message 1 of 4 (843 Views)
Accepted Solution

3d Dashed Line / Arrow Family ?

843 Views, 3 Replies
12-13-2013 04:37 AM

I'm building a couple of 3d massign models and a thought occured to me.

 

Is it possible to create a 3d dashed line family (ideally with a 3d arrow head graphic) that could be used via a drawn line in the model to act as a path ?

 

If possible, then parameters could be used to set height, depth, dash gap etc.

 

It would allow for quick 3d annotation on views - including shadows to help them 'pop'

 

Not quite sure where to start. I can use sweeps etc. but not sure if a family can use a path that is essentially outside of the family itself.

 

Could it even use an MEP family - based around something like a duct route, but substituting a dashed 3d form and a termination of an arrow ?

 

Not a critical item - just a thought on what might be possible.

 

Thanks,

Martin

OK - probably blindingly obvious to you lot, but it only dawned on me on the way home tonight.

 

Curtain Walling.

 

Just made a simple padded block cladding panel, and a couple of alternatives for arrow ends, and hey presto - flexible 3d arrow lines that can be altered to different depths, padding etc.

 

3d-Arrow-Lines.jpg

A bit clumsy as I have it set up for the moment, I need to refine things a bit to give myself more options on setting colour more universally by Type to allow me to switch whole runs from one colour / type to another - but as a principle it is what I'm after.

Mentor
MKEllis
Posts: 228
Registered: ‎03-02-2013
Message 2 of 4 (813 Views)

Re: 3d Dashed Line / Arrow Family ?

12-13-2013 11:42 AM in reply to: MKEllis

OK - probably blindingly obvious to you lot, but it only dawned on me on the way home tonight.

 

Curtain Walling.

 

Just made a simple padded block cladding panel, and a couple of alternatives for arrow ends, and hey presto - flexible 3d arrow lines that can be altered to different depths, padding etc.

 

3d-Arrow-Lines.jpg

A bit clumsy as I have it set up for the moment, I need to refine things a bit to give myself more options on setting colour more universally by Type to allow me to switch whole runs from one colour / type to another - but as a principle it is what I'm after.

Mentor
MKEllis
Posts: 228
Registered: ‎03-02-2013
Message 3 of 4 (790 Views)

Re: 3d Dashed Line / Arrow Family ?

12-14-2013 02:55 AM in reply to: MKEllis

Wasn't sure if accepting your own post as a solution is acceptable / or frowned on here - but it seemed appropriate, hope no-one minds.

 

Martin

*Expert Elite*
rosskirby
Posts: 886
Registered: ‎04-08-2008
Message 4 of 4 (769 Views)

Re: 3d Dashed Line / Arrow Family ?

12-14-2013 02:14 PM in reply to: MKEllis

Perfectly acceptable.  Thanks for the post.

Ross Kirby
BIM Manager
Arcturis
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.