Community
Revit Architecture Forum
Welcome to Autodesk’s Revit Architecture Forums. Share your knowledge, ask questions, and explore popular Revit Architecture topics.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Hatch Pattern Madness

1 REPLY 1
Back to Revit Products Category
Back to Topic Listing
Reply
Message 1 of 2
jamiew2ULKB
Contributor
650 Views, 1 Reply
‎12-03-2019 01:07 PM
‎12-03-2019 01:07 PM

Hatch Pattern Madness

Guys for the life of me I cannot explain this. I have a spacing of 4 ' - 5 1/2" in there and it spits out 4' - 2 5/16".

 

I even made a pattern file myself that has 53.5 for the offset.

 

0,0,0,0,51
90,0,0,0,53.5,51,0

 

And it STILL spits out 4' - 2 5/16". I'm going mad trying to figure it out.

 

Capture.PNG

Report
0 Likes
Reply
1 REPLY 1
Message 2 of 2
jamiew2ULKB
Contributor
in reply to: jamiew2ULKB
‎12-03-2019 01:12 PM
‎12-03-2019 01:12 PM

Nevermind, that wall is at an angle and I was looking at an elevation set to a plane a few degrees off.

Report
Reply
Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report


Autodesk Design & Make Report

Report a website issue