QuickCAD

Reply
*Hashmy, Christel Al
Message 1 of 3 (27 Views)

insufficient memory

27 Views, 2 Replies
03-08-2000 03:32 AM
After working with Quickcad for approx an hour, the screen starts to go
black and white , followed by "insufficient memory" warning. My version is
3.02. I have 64 RAM installed and a large hard disk and never run any other
program at the same time. Can anybody help?
Charles Sappa
*Smith, Harvey
Message 2 of 3 (27 Views)

Re: insufficient memory

03-10-2000 03:24 PM in reply to: *Hashmy, Christel Al
Christal,

There's a few things to fiddle with maybe. Check the
connectors on the back of both the monitor and the video
card. You might even want to open the computer and reseat
the card. If this were actually a problem, you probably
would see the same effect with other programs.

Also, check to make sure you have the latest video drivers
installed.

Lastly, try reinstalling the program with no active programs
running in the background, including virus protection.

Stay tuned for other suggestions.

This sounds like a system problem rather than a QC problem.

H

Christel Al Hashmy wrote:
>
> After working with Quickcad for approx an hour, the screen starts to go
> black and white , followed by "insufficient memory" warning. My version is
> 3.02. I have 64 RAM installed and a large hard disk and never run any other
> program at the same time. Can anybody help?
> Charles Sappa
*Tan, Chye
Message 3 of 3 (27 Views)

Re: insufficient memory

03-11-2000 06:02 AM in reply to: *Hashmy, Christel Al
I've experience with other software, that has this insufficient " memory
problems" especially one with rendering abilities.

It seems to me that the computer actually create large file in the temp
directory when you do rendering and some other stuff.

go to your temp directory to check this out, perhaps you might need to erase the
unwanted file.

good luck!

Christel Al Hashmy wrote:

> After working with Quickcad for approx an hour, the screen starts to go
> black and white , followed by "insufficient memory" warning. My version is
> 3.02. I have 64 RAM installed and a large hard disk and never run any other
> program at the same time. Can anybody help?
> Charles Sappa
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.