QuickCAD

Reply
Member
henryw
Posts: 5
Registered: ‎04-20-2007
Message 1 of 1 (350 Views)

fatal internal erro

350 Views, 0 Replies
08-29-2008 07:38 AM
I opened a drawing to perform some modifications. I attempted to move small schematic over a little to make room for another schematic. As soon as I boxed it in, I got the fatal error message, recovery file mesage, etc. On further playing with it, the item that was causing the error wa a symbol from my libraary that I created and have used many times. I deleted every wire and connection point on the schematic, but when I try todeletel the symbol...fatal error. Any ideas?

Henry W
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.