QuickCAD

Reply
*Smith, Harvey
Message 1 of 1 (13 Views)

Does QC7 have "extend"?

13 Views, 0 Replies
03-26-2000 11:57 AM
Hiya, Dave,

Try the TrimCorner or TrimEdge tools. That usually does it, unless you have some
special circumstance.

If you have time, go over to the AutoSketch newsgroup, and back on 2/28/00 there
was a post called "AutoSketch 7.0 - Line Extension" from Chris Buck. There was a
good deal of discussion about this line extension business. I suspect everything
possible about this issue was discussed for AS R7. More than likely for QC R7,
too.

H
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.