QuickCAD

Reply
*Bob Thompson
Message 1 of 3 (161 Views)

Curved text

161 Views, 2 Replies
03-13-2007 07:15 AM
Is there a way to place text on an arc, without placing individual
letters and rotating them "x" degrees?
Active Contributor rsn
Active Contributor
rsn
Posts: 37
Registered: ‎05-31-2006
Message 2 of 3 (161 Views)

Re: Curved text

03-13-2007 04:01 PM in reply to: *Bob Thompson
Messing around with circular arrays is another way.
*Bob Thompson
Message 3 of 3 (161 Views)

Re: Curved text

03-13-2007 05:56 PM in reply to: *Bob Thompson
Thanks for the tip about circular arrays..I'll try it. As far as
my other problem, I've only drawn one line, not two. And I'm not
using layers, just a simple drawing (lines and arcs), but it acts
like layers to me if you delete off of sheet one, but not sheet
two. I'll keep experimenting as to what happened, since I must
have changed a setting or something. I've never had this problem
until now.

Thanks....Bob

wrote in message
news:5517353@discussion.autodesk.com...
Messing around with circular arrays is another way.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.