QuickCAD

Reply
New Member
shagg28716
Posts: 1
Registered: ‎03-21-2007
Message 1 of 2 (128 Views)

changing a default text

128 Views, 1 Replies
03-21-2007 11:04 AM
within the last week my quickcad has experienced a change in font. I am not sure what change occurred that might have caused this reaction but now all quickcad maps that i open display in a lucida sans unicode. This format is troublesome since it stretches text across and off the page. Is there a default text for quickcad and does anyone know how i can change that default text?
*Bob Thompson
Message 2 of 2 (128 Views)

Re: changing a default text

03-22-2007 04:18 PM in reply to: shagg28716
The only way I know to change default text, is to make open a new
drawing, change the text type, then save it as a template. I
looked in the registry, and couldn't find any 'text' settings I
could change. Bob


wrote in message
news:5526233@discussion.autodesk.com...
within the last week my quickcad has experienced a change in font.
I am not sure what change occurred that might have caused this
reaction but now all quickcad maps that i open display in a lucida
sans unicode. This format is troublesome since it stretches text
across and off the page. Is there a default text for quickcad and
does anyone know how i can change that default text?
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.