Quantity Takeoff

New Member
Posts: 2
Registered: ‎05-31-2012
Message 1 of 1 (583 Views)

QTO Legend & Report Not Matching

583 Views, 0 Replies
05-31-2012 10:55 AM

I am having trouble when altering an existing takeoff with a report driven off of that takeoff. In this situation, I have a linear takeoff of 206. I created a report and saved the document. I went back in to the document, deleted the old report, added 3lf of takeoff. The legend is correct (209), but when I run the report it shows 206. I have tried saving the document at different intervals to see if that clears the report data, I have exited completely out prior to entering the add'l qty. I have also expanded the takeoff to an exaggerated amount (227) and the report read that takeoff, but as soon as I backed down to the 209, it reported 206.


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.