Quantity Takeoff

Quantity Takeoff

Reply
New Member
AngieN
Posts: 1
Registered: ‎11-15-2012
Message 1 of 1 (880 Views)

can't calculate a Volume

880 Views, 0 Replies
11-15-2012 01:46 PM

When I go to create a volume report I get no volume everytime.....

 

I have a design profile, an assembly, a corridor, a corridor surface, an existing surface, sample lines sampling the design corridor and the existing surface, and I created section views and each section looks correct.

I went to compute materials, selected earthworks, selected my existing surface and my corridor surface, checked the condition to be sure it was selecting the area below the existing and above the design, clicked apply. Then tryed to run a volume report.....and I get nothing.

 

I'm not sure what I'm missing. I have done this once before on another project and I can't see any difference between the two??

 

Thanks for the help.

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.