I'm using Autocad 2012 and I'm struggling to get space acivate the pan function!!
I follow the procedure to modify the keyboard shoutcut but the button SPACE is not accepted as keyboard shortcut for anything.
Actually Keyboard shoutcut only accepts CTRL+... or SHIFT+... etc
NO SINGLE LETTER (or SPACE) are accepted.
Please can someone help me to easlily pan into my drawings (I hope it is clear now that i do not want to use my weel button on the mouse )
Thanks for the answer,
I was hoing in the space bar shortcut after reding a few post about it.. my mistake.
HOWEVER: there is a way to have a PAN shortcut on keyboar that acts as mouse centre button?
when push = PAN
you release = NO more PAN, you go back to previous commnad
keyboard pan shortcut:
push = PAN
release = nothing, PAN stays up you click a new command
This is driving me creazy ^^
Hope there is some help here..
AS stated in my prevous message I have given up at the ideas of using the space bar.
What I still hope, is to be able to PAN using whatever keyboard combination in the way the 3rd mouse button works (see my prevous reply)
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!