I have a logitech keyboard & mouse on a Windows 7 professional 64 bit, Quadro 4000. All drivers are up to date.
Problem is there are two thumb buttons I programmed (one for esc the other F3) though setpoint that do not work. In fact, only the right, left & middle buttons on the mouse work.
I have programmed them and they work in other programs but not in AutoCAD 2012.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!