Pointing Devices and Displays

Pointing Devices and Displays

Reply
Contributor
fmichaelsikes
Posts: 11
Registered: ‎06-26-2008
Message 1 of 4 (879 Views)

CROSSHAIRS "JUMPING"

879 Views, 3 Replies
06-22-2010 09:40 AM

DOES ANYONE KNOW HOW TO ADJUST THE CROSSHAIR MOVEMENT

SO IT IS SMOOTH INSTEAD OF JUMPING?

Contributor
maximo916
Posts: 20
Registered: ‎03-05-2009
Message 2 of 4 (862 Views)

Re: CROSSHAIRS "JUMPING"

07-14-2010 09:01 AM in reply to: fmichaelsikes

Turn SNAP off.

In the command prompt....SNAP>Enter>OFF

 

I've found that anytime I do DVIEW, Snap turns itself on. Not sure why.

Active Contributor
rmitchler
Posts: 33
Registered: ‎01-08-2008
Message 3 of 4 (645 Views)

Re: CROSSHAIRS "JUMPING"

12-16-2010 02:21 PM in reply to: fmichaelsikes

To add to that turn your grid off it also causes the jump between grid spacing.

 

Robert

New Member
texankevin
Posts: 1
Registered: ‎12-08-2010
Message 4 of 4 (461 Views)

Re: CROSSHAIRS "JUMPING"

03-14-2011 12:52 PM in reply to: fmichaelsikes
check your grid snaps, you can turn them off or change to snap size. Really unless you are working with Architechure you dont really even need to use grid snaps. good luck
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.